Installation And Connection - Whirlpool ACM 224 Instructions For Use Manual

Installation and connection

Important
Do not install the appliance next to
refrigerators or freezers. The heat
emitted by the appliance will lead to
an increased energy consumption
of cooling appliances.
• Appliance to be installed in
accordance with the local authority
requirements for gas, electricity
and any other authority having
jurisdiction.
• Carry the appliance with at least
two persons.
NOTICE
Material damage!
The door and/or handle must not be
used for lifting or moving the
appliance.
• The appliance must be placed
directly on the floor. It must not be
placed onto a base or a pedestal.
DANGER
Risk of explosion by damage of
the safety tube!
The safety tube must not be
clamped, bent or trapped or come
into contact with hot parts of the
appliance.
Connection to the mains supply
Important
This appliance must be earthed!
Our company shall not be held
responsible for any damage caused
by using the appliance without
earthed socket.
DANGER
Risk of electric shock, short
circuit or fire by unprofessional
installation!
The appliance may be connected
to the mains supply only by an
authorized qualified person and the
appliance is only guaranteed after
correct installation.
DANGER
Risk of electric shock, short
circuit or fire by damage of the
mains lead!
The mains lead must not be
clamped, bent or trapped or come
into contact with hot parts of the
appliance.
If the mains lead is damaged, it
must be replaced by a qualified
electrician.
The mains supply data must
correspond to the data specified on the
rating plate of the appliance. The rating
plate is either seen when the door or
the lower cover is opened or it is
located at the rear wall of the appliance
depending on the appliance type.
The supply cable of the appliance must
correspond to the specifications; see
technical data table Technical
specifications, page 5.
DANGER
Risk of electric shock!
Before starting any work on the
electrical installation, please
disconnect the appliance from the
mains supply.
1. If no all-pole separation from the
mains supply is possible, a
separation unit must be connected
with a contact distance of 3 mm min.
(fuses, line safety switches,
contactors) all poles which should
11 | EN