1. ROPS knob (locked
position)
2. Pull the ROPS knob out,
and rotate it 90 degrees to
change the roll bar position
Adjusting the Tracking
1. Disengage the blade-control switch (PTO).
2. Drive to an open, flat area, and move the
motion-control levers to the neutral-locked position.
3. Move the throttle midway between Fast and Slow.
4. Move both motion-control levers forward until they
both hit the stops in the T-slot.
5. Check which way the machine tracks.
6. If it tracks to the right, loosen the bolts and adjust
the left stop plate rearward on the left T-slot until the
machine tracks straight
7. If it tracks to the left, loosen the bolts and adjust the
right stop plate rearward on the right T-slot until the
machine tracks straight
8. Tighten the stop plate
Figure 61
3. Roll bar in the upright
position
4. Roll bar in the folded
position
(Figure
62).
(Figure
62).
(Figure
62).
Left control lever shown
1. Control lever
2. Bolt
Checking the Tire Pressure
Service Interval: Every 50 hours/Monthly (whichever
comes first)
Maintain the air pressure in the rear tires at 90 kPa (13 psi).
Uneven tire pressure can cause uneven cut. Check the tires
when they are cold to get the most accurate pressure reading.
Note: The front tires are semi-pneumatic tires and do not
require air pressure maintenance.
45
g027340
Figure 62
3. Stop plate
Figure 63