Controls System Maintenance; Adjusting The Control-Handle Position - Toro Z Master Professional 6000 74922 Operator's Manual

7. Remove the belt from the hydraulic unit drive pulleys
and the engine pulley.
8. Install the new belt around engine pulley and the 2
drive pulleys.
9. Using a ratchet in the square hole in the idler arm,
install the idler spring to the frame
10. Install the mower belt; refer to
Belt (page 51).
(Figure 79).
Replacing the Mower
53
Controls System
Maintenance
Adjusting the Control-Handle
Position
There are 2 height positions for the control levers—high and
low. Remove the bolts to adjust the height for the operator.
1. Disengage the PTO, move the motion-control levers to
the neutral-locked position, and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Loosen the bolts and flange nuts installed in the levers
(Figure 80).
4. Align the levers in the front-to-rear position by
bringing the levers together to the neutral position, and
slide them until they are aligned, then tighten the bolts
(Figure 81).
Figure 80
1. Bolt
2. Handle
3. Control lever
4. Nut