Table of Contents
Advertisement
The light bulb is located on the back wall of the oven.
Before replacing the bulb, disconnect electrical power
to the range at the main fuse or circuit breaker panel
or unplug the range from the electrical outlet. Let the
bulb cool completely before removing it. For your
safety, do not touch a hot bulb with a damp cloth. If
you do, the bulb will break.
To remove: Unscrew the cover afid remove the bulb.
To
Put in a new 40-watt appliance bulb.
replace:
Install and tighten the cover. Reconnect the electrical
power to the cooking center.
NOTE: A 40-watt appliance bulb is smaller than
a standard 40-watt household t ulb.
Cooktop
Surface
CAUTION: Do not touch the bulb when it is hot
or with wet hands. Never wipe light area with a wet
before removing.
To replace bulb:
1. Remove the retaining panel (remove 3 screws)
securing the top of the lamp glass panel.
2. Carefully pull the lamp glass out by the top edge,
lifting it upward and out of the lower slot.
3. Remove the bulb by sliding your fingers under the
bulb at each end and pulling bulb straight out.
4. Replace the bulb with one of the same length
and wattage.
5. Slip the lamp glass with the end trims back into
the lamp glass retainer.
To replace starter:
1. Remove lamp glass as explained above.
2. Grasp starter, turn it counterclockwise, about
1/4 turn, and lift out. Replace with one of the same
wattage.
3. Reposition lamp glass as explained above.
48
CARE AND CLEANING
(continued)
Starter
Bulb
'\
Glass
cover
"
-
I
panel
Starter
Advertisement
Table of Contents
