Fiber Optic Ethernet Ports - Siemens RUGGEDCOM RX1500 Installation Manual

Chapter 3
Communication Ports
Figure 28: 4-Pin M12 D-Coded Ethernet Port Pin
Configuration
a
Terminated at GND (Ground)
For specifications on the available copper Ethernet ports, refer to
Specifications".
Section 3.2

Fiber Optic Ethernet Ports

Fiber optic Ethernet ports are available with either MTRJ (Mechanical Transfer Registered Jack), LC (Lucent
Connector), SC (Standard or Subscriber Connector) or ST (Straight Tip) connectors. Make sure the Transmit (Tx)
and Receive (Rx) connections of each port are properly connected and matched to establish a proper link.
1
Figure 29: MTRJ Port
1. Tx Connector 2. Rx Connector
1
Figure 31: SC Port
1. Tx Connector 2. Rx Connector
For specifications on the available fiber optic Ethernet ports, refer to
Specifications".
20
2
Figure 30: LC Port
1. Tx Connector
2
Figure 32: ST Port
1. Tx Connector
Pin 10/100/1000Base-Tx Signal
7
8
Pin
1
2
3
4
Section 4.4, "Copper Ethernet Port
1
2. Rx Connector
1
2. Rx Connector
Section 4.5, "Fiber Optic Ethernet Port
RUGGEDCOM RX1500
Installation Guide
C+
C-
10/100Base-Tx Signal
TX+
RX+
TX-
RX-
2
2
Fiber Optic Ethernet Ports