Table of Contents
Advertisement
● External trigger input recommended circuit
- Isolated I/F
CAMERA Inside
DC3.3V
10kΩ
- Non-Isolated I/F
CAMERA Inside
DC3.3V
10kΩ
Notes of trigger input cable:
- The recognition of the trigger signal depends on the length, characteristic or driving current of the cable. Therefore
please confirm your system about those conditions.
- Pin 3 is signal ground. It isn't conducted with camera frame.
Using shield cable, terminal processing of the shield is referred as above.
- Please confirm the EMC adaptability in whole of your system.
Copyright © 2016 TOSHIBA TELI CORPORATION, All rights reserved.
4
3
Camera
GND
4
3
Camera
GND
Your system
Photocoupler
Your
Secondary GND
Your system
Your
FRAME GND
22 / 81
http://www.toshiba-teli.co.jp/en/index.htm
Your
GND
Your
GND
D4253386A
Advertisement
Table of Contents
