Gain - Toshiba BU302MG Instruction Manual

Gain

This section describes Gain control of LuminanceControl category of the BU series.
This control adjusts the gain of the image.
● Registers
Register Visibility
Gain Beginner
● Setting
- Set Manual Gain
Set the following value to "Gain" register. Setting value is Float type. This setting value is valid only at
Manual Gain mode setting.
The formula of Gain value is as follows;
● Note
Notes on gain setting:
Setting the gain value too high increases noises. When you adjust the brightness of the image, I ask you to have final
image quality checked with your environment.
Copyright © 2016 TOSHIBA TELI CORPORATION, All rights reserved.
output
signal
Gain
Gain
Access
R/W Sets the absolute Gain.
Gain
Minimum (*)
Maximum
output signal = input signal x 10
59 / 81
input signal
Description
Value
0.00 [dB]
24.00 [dB]
* initial factory setting
Gain
20
http://www.toshiba-teli.co.jp/en/index.htm
D4253386A