Panasonic KX-TDA200 Features Manual page 367

•
A maximum of two ports of each BRI card can be assigned to transmit extension status information ("ON").
•
Through system programming, it is possible to assign a maximum number of "hops" (transfers between
PBXs) that extension status information can travel. Each time a piece of extension status information is
forwarded to another PBX, its counter is increased by one. When this counter reaches the assigned
maximum, the data is discarded. This is used to prevent data from circling unnecessarily around the
network.
® 11.2 [9-2] Network Data Transmission—
Feature—Data Transmission Counter
•
If it is not possible to remotely turn off transmission of extension status information using the NDSS Monitor
Release feature because of network conditions, it is possible to perform the same operation directly through
system programming at the monitored PBX.
® 6.8 [4-1-6] Wired Extension—NDSS Link Data - Send
® 6.15 [4-2-4] Portable Station—NDSS Link Data - Send
•
When using a private IP network, if extension status information is lost by the network, in some cases an
NDSS button may not be able to display the status of the relevant extension.
•
NDSS can not be used when two PBXs are networked using the TIE Line Call by Own PBX Extension
Number feature (® 1.30.1 TIE Line Service).
PC Programming Manual References
3.14 [1-1] Slot—Port Property - BRI Port—ISDN CO—
3.16 [1-1] Slot—Port Property - PRI Port (KX-TDA100/KX-TDA200/KX-TDA600 only)—CO Setting—
Networking Data Transfer
4.11 [2-7-1] Class of Service—COS Settings—Programming & Manager—
6.5 [4-1-4] Wired Extension—Flexible Button
→ Type
→ Dial (for NDSS)
6.8 [4-1-6] Wired Extension—NDSS Link Data - Send
6.13 [4-2-3] Portable Station—Flexible Button
→ Type
→ Dial (for NDSS)
6.15 [4-2-4] Portable Station—NDSS Link Data - Send
6.17 [4-3] DSS Console
→ Type
→ Dial (for NDSS)
11.2 [9-2] Network Data Transmission
11.3 [9-3] Network Operator (VoIP)
11.4 [9-4] NDSS Key Table
PT Programming Manual References
[511] Manager Assignment
Feature Guide References
1.30.1 TIE Line Service
1.30.2 Voice over Internet Protocol (VoIP) Network
1.30.4 QSIG Standard Features
User Manual References
1.2.1 Basic Calling
Network Data Transmission for Centralised Operator
Networking Data Transfer
1.30.5 QSIG Enhanced Features
Manager
Feature Guide 367