Lubrication - Toro Reelmaster 4000-D 03706 Operator's Manual

Lubrication

The machine has grease fittings that must be lubricated
after every 50 hours of operation with No. 2 General
Purpose Lithium Base Grease. Lubricate fitting
immediately after every washing regardless of interval
listed. The lubrication points are: lift arms (5) (Fig. 24),
rear axle (6) (Fig. 25), floating or fixed head kit pivots
(Fig. 26) and cutting unit reel and roller bearings (Fig. 27).
Also, grease fitting on reel control valve (not shown),
located under right hand console.
Figure 24
Figure 25
Note: Remove the plastic caps over the fittings on the
floating or fixed head kit pivots and replace after greasing
(Fig. 26).
Figure 26
Figure 27
28