Specifications; General Specifications - Toro Reelmaster 4000-D 03706 Operator's Manual

Specifications

Note: Specifications and design subject to change without notice.

General Specifications

Engine
Cooling System
Fuel System
Hydraulic System
Traction System
Cutting Unit Drive System
Seat
Diagnostic System
Steering System
Brakes
Electrical System
Interlock System
Warning Systems
Ground Clearance
Height of cut
Wheel Thread
Wheel Base
Operating Circle
Reel Speed
Clip
Kubota, four–cycle, four cylinder, 134 cu–in. displacement, water cooled diesel
engine. Rated 40 hp @ 2300 rpm, 23:1 compression ratio. Low idle – 1200 rpm,
high idle – 2500 rpm. Injection Timing – 17–18 BTDC. Oil capacity is 8 qt. (7.6 L)
with filter.
Capacity is 3.7 gal. (14 L) of 50/50 mixture of ethylene glycol anti–freeze.
Capacity is 15 gal. (56.8 L) .
Reservoir capacity is 9.3 gal. (35.2 L) and total system capacity is 18.2 gal. (69 L).
Replaceable breather element. Replaceable spin–on filter element.
Ground speed is 0–12.5 mph (0–20 km/h).
Adjustable reel speed to match clip to ground speed. Backlap reel speed is 385
rpm.
Adjusts 6 in. (15.2 cm) forward and backward. Adjustable backrest and
three–positions for operator weight. Integral seat switch at rear of bottom seat
cushion.
Test ports for traction system, cutting unit drive system, lift/counterbalance,
lift/relief, steering circuits and charge pressure are located near individual
components.
Automotive type, full power.
Hand brake automatically locks traction linkage in neutral. With traction motor
wheel locks engaged, twin disc brakes provide positive, emergency braking.
12 volt, 66 amp hour (DIN) battery and 40 amp alternator. Negative ground.
Designed to stop engine if operator gets off seat while cutting unit drive lever is
either in forward or reverse. Prevents engine from starting unless parking brake is
engaged, traction pedal is in neutral and cutting units are disengaged. Low
hydraulic oil level and high engine temperature protection systems stop engine
from running.
Water in fuel, hydraulic oil filter, engine coolant temperature, engine oil pressure,
voltage indicator, air cleaner clogged, hydraulic oil temperature and hydraulic oil
level.
Approx. 7 in. (17.8 cm)
5 Blade Cutting Unit: 1 – 3 in. (25 – 76 mm)
7 Blade Cutting Unit: 3/8 – 1 3/4 in. (9.5 – 45 mm)
11 Blade Cutting Unit: 3/8 – 3/4 in. (9.5 – 19 mm)
53 in. (135 cm)
57 in. (145 cm)
60 in. (152 cm)
800 – 1000 rpm
Note: 1200 rpm is attainable with a special coupler.
5 Blade Cutting Unit: .176 in. per mph (.352 in. at 2 mph – 1.32 in. at 7.5 mph)
7 Blade Cutting Unit: .126 in. per mph (.252 in. at 2 mph – .945 in. at 7.5 mph)
11 Blade Cutting Unit: .080 in. per mph (.16 in. at 2 mph – .600 in. at 7.5 mph)
12