Separating The Cutting Unit From The Traction Unit - Toro 30722 Groundsmaster 300 Operator's Manual

Figure 22
Figure 23
Figure 24
1. Fill/check plug
Separating the Cutting Unit
from the Traction Unit
1. Position the machine on a level surface, lower the
cutting unit to the shop floor, shut the engine off, and
engage the parking brake.
2. Remove the self-tapping screws securing the shield to
the top of the cutting unit and set the shield aside.
3. Drive the roll pin out of the yoke and input shaft of the
gear box (Fig. 26). Also, loosen the capscrews and
locknuts. Slide the yoke off of the input shaft. If the
traction unit will be used without the cutting unit, drive
the roll pin out of the yoke at the PTO pivot shaft and
remove the entire universal shaft from the traction unit.
1. PTO yoke
2. Roll pin
3. Capscrews and locknuts
17
1
Figure 25
Figure 26
4. Right-hand push arm
5. Yokes in phase