Positioning The Flow Baffle; Using The Lift Assist Lever - Toro 74450TE Z400 Z Master Operator's Manual

Figure 22
1. Cam lock
2. Lever

Positioning the Flow Baffle

The following figures are only recommendations for
use. Adjustments will vary by grass type, moisture
content, and height of grass.
Note: If the engine power draws down and the mower
ground speed is the same, open up the baffle.
Position A
This is the full rear position. The suggested use for this
position is a follows.
• Use for short, light grass mowing conditions.
• Use in dry conditions.
• For smaller grass clippings.
• Propels grass clippings farther away from the
mower.
Figure 23
Position B
Use this position when bagging.
3. Rotate cam to increase or
decrease locking pressure
4. Slot
Position C
This is the full open position. The suggested use for
this position is as follows.
• Use in tall, dense grass mowing conditions.
• Use in wet conditions.
• Lowers the engine power consumption.
• Allows increased ground speed in heavy conditions.
• This position is similar to the benefits of the Toro
SFS mower.

Using the Lift Assist Lever

The lift assist lever is used along with the height-of-cut
lever for raising the mower deck. This allows for easier
raising of the mower deck.
22
Figure 24
Figure 25