Hydraulic System Maintenance; Servicing The Hydraulic System - Toro 74450TE Z400 Z Master Operator's Manual

Figure 56
1. Clevis pin in slot
2. Nut
3. Nut-Left hand thread
4. Adjustment bolt
5. Pump rod
7. Check where the control lever is relative to the notch
in the console (Figure 55). It should be centered,
allowing the lever to pivot outward to the neutral
lock position.
8. If adjustment is needed, loosen the nut and jam nut
against the yoke (Figure 56).
9. Apply slight rearward pressure on the motion control
lever, and turn the head of the adjustment bolt in
the appropriate direction until the control lever is
centered in the neutral lock position.
Note: Keeping rearward pressure on the lever will
keep the pin at the end of the slot and allow the
adjustment bolt to move the lever to the appropriate
position.
10. Tighten the nut and jam nut (Figure 56).
11. Repeat on the opposite side of machine.
6. Double nuts
7. Jam nut
8. Yoke
9. Ball joint
Hydraulic System
Maintenance
Servicing the Hydraulic
System
Hydraulic Oil Type: Toro
hydraulic oil or Mobil
Hydraulic System Oil Capacity: 67 ounces (2.0 l)
Important: Use oil specified. Other fluids could
cause system damage.
Checking the Hydraulic Fluid
Service Interval: After the first 8 hours
Every 50 hours
Note: There are two ways of checking the hydraulic oil.
One is when the oil is warm and one is when the oil is
cold. The baffle inside the tank has two levels depending
if the oil is warm or cold.
1. Position the machine on a level surface and set the
parking brake.
2. Clean the area around filler neck of hydraulic tank
(Figure 57).
3. Remove the cap from the filler neck. Look inside to
check if there is fluid in the reservoir (Figure 57).
4. If there is no fluid, add fluid to the reservoir until it
reaches the cold level of the baffle.
5. Run the machine at low idle for 15 minutes to allow
any air to purge out of the system and warm the
fluid. Refer to Starting and Stopping the Engine in
Operation (page 14).
6. Recheck the fluid level while the fluid is warm. The
fluid should be between cold and hot.
7. If required, add fluid to the hydraulic tank.
Note: The fluid level should be to the top of the hot
level of the baffle, when the fluid is hot (Figure 57).
8. Install the cap on filler neck.
43
® HYPR-OIL ™ 500
® 1 15W-50.