Checking The Boom Hinge Springs - Toro 41198 Multi-Pro 1250 Operator's Manual

1. Spray Pro monitor
2. Bracket
3. Loosely install the 2 carriage bolts, rubber
washers, and knobs on the bracket as illustrated in
Figure Figure 5 and Figure 6.
Note: Install the carriage bolts and rubber washers
inside of the bracket and the knobs on the outside.
1. Carriage bolt
2. Rubber washer
4. Remove the large grommet from the hole in the dash
and thread the cables on the monitor through the
grommet and the dash.
5. Install the grommet into the dash.
6. Install the Spray Pro monitor over the carriage bolt
heads (Figure 5) and tighten the knobs to secure it.
7. Connect the Spray Pro wire connectors to the wire
connectors located under the dash (Figure 7).
Figure 5
3. Flange-head bolts,
1/4 x 3/4 inch
4. Knob
Figure 6
3. Knob
4. Bracket
1. Connectors from the
sprayer
3
Checking the Boom Hinge
Springs
No Parts Required
Procedure
Important: Operating the spray system with
the boom hinge springs under the incorrect
compression could damage the boom assembly.
Measure the springs and use the jam nut to
compress the springs to 1.56 inches if necessary.
The sprayer is shipped with the boom extensions swung
forward to facilitate packaging of the machine. The
springs are not fully tightened at the time of manufacture
to allow the booms to be in this position for transit.
Before operating the machine, the springs must be
adjusted to the correct compression.
1. If necessary, remove the packing components that
secure the right and left extension booms during
shipping.
2. Support the booms while they are extended to the
spray position.
3. At the boom hinge, measure the compression of the
upper and lower springs while the booms are in their
extended position (Figure 8).
A. All springs must be compressed until they
measure 1.56 inches.
15
Figure 7
2. Connectors from the
monitor