Adjusting The Booms To Level; Completing The Setup: Learning More About Your Product - Toro 41198 Multi-Pro 1250 Operator's Manual

B. Use the jam nut to compress any spring that
measure greater than 1.56 inches.
1. Boom hinge spring
4. Repeat the procedure for each spring on both boom
hinges.
5. Move the booms into the transport "X" position.
See Operating the Booms in the Operation section
for more information.
4

Adjusting the Booms to Level

No Parts Required
Procedure
1. At the operator's position, turn the ignition key to
On to energize the system.
2. Move the booms into position so that they are level
with the ground.
3. Remove the key and exit the operator's position.
4. At the hinge, adjust the position of the bumpers so
the boom can not move past level with the ground.
Take care to make sure the bumper is level.
5. Tighten the bolt and nut to lock the bumpers into the
adjusted position. Torque the fasteners to 135-165
ft-lbs (183-223 N-m).
Figure 8
2. Jam nut
Note: The bumper may experience some compression
over time. If the booms drop below level, use this
procedure to readjust the bumper position needed.
5
Completing the Setup:
Learning more about your
product.
Parts needed for this procedure:
1 Ignition key
1 Operator's Manual
1
Engine Operator's Manual
1 Parts Catalog
1 Operator Training Material
1 Registration Card
1 Pre-delivery Inspection Sheet
Procedure
1. Read the manuals.
2. View the Operator training material.
3. Complete the registration card and return to Toro.
4. Store the documentation in a safe place.
16