Adding Rear Weight - Toro 04540 Operator's Manual

9. With the latches on the suspension-arm bar pointing
up (i.e., open) (Figure
down so that the bar fits over the bar across the top of
the cutting unit (Figure
1
Figure 12
1. Latch—closed position
2. Suspension-arm bar
1
2
Figure 13
1. Suspension-arm bar
10. Close the latches down and around the cutting-unit bar
and lock them in place
Note: A "click" can be heard and felt when the latches
are properly locked in place.
11. Coat the spline shaft of the cutting-unit motor with
clean grease (Figure
12. Insert the motor into the left side of the cutting unit
(as viewed from the operator's position) and pull the
motor-retaining bar on the cutting unit toward the
motor until you hear an audible "click" from both sides
of the motor (Figure
12), push the suspension arm
13).
2
3. Latch—open position
2. Cutting-unit bar
(Figure 12).
14).
14).
3
g014609
1. Reel motor
2. Spline shaft
13. Mount a grass basket onto the basket hooks on the
suspension arm.
14. Repeat this procedure for the other cutting units.
15. Connect the cutting-unit power-disconnect couplers;
refer to
(page 24).
7
g01461 1

Adding Rear Weight

Parts needed for this procedure:
Weight kit, 121–6665 (purchase seperately) Note: not
1
required for units with the 3 wheel drive kit installed.
Procedure
This unit complies with the ANSI B71.4-2004 and EN 836
Standards when equipped with weight kit 121–6665.
Note: If the unit is equipped with a three wheel drive kit
additional weight is not required to meet ANSI B71.4-2004
and EN 836 standards.
17
Figure 14
3. Cavity
4. Motor-retaining bar
Cutting Unit Power Disconnect Connectors