Lubrication; Greasing The Bearings And Bushings - Toro 30807 Operator's Manual

Lubrication

Greasing the Bearings And
Bushings
Service Interval: Every 50 hours (Lubricate all bearings and
bushings daily when conditions are dusty
and dirty.)
Every 500 hours/Yearly (whichever comes first)
The machine has grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium Base Grease.
Bearings and bushings must be lubricated daily when
operating conditions are extremely dusty and dirty. Dusty
and dirty operating conditions could cause dirt to get into
the bearings and bushings, resulting in accelerated wear.
Lubricate grease fittings immediately after every washing,
regardless of interval specified.
The grease fitting locations and quantities are:
•
Rear cutting unit pivot (Figure 37)
Figure 37
•
Front cutting unit pivot (Figure 38)
Figure 38
•
SideWinder cylinder ends (2) (Figure 39)
•
Steering pivot (Figure 40)
•
Rear lift arm pivot and lift cylinder (2) (Figure 41)
42
Figure 39
Figure 40
Figure 41