Product Overview; Controls - Toro 30807 Operator's Manual

Product Overview

Controls

Figure 21
1. Forward traction pedal
2. Reverse traction pedal
3. Mow/transport slide
Traction Pedals
Press the traction forward pedal (Figure 21) to move forward.
Press traction reverse pedal (Figure 21) to move backward or
to assist in stopping when moving forward. Also, allow the
pedal to move or move it to the neutral position to stop the
machine.
Mow/Transport Slide
Using your heel, move the mow/transport slide (Figure 21)
to the left to transport and to the right to mow. The cutting
units will only operate in the mow position.
Important: The mow speed is set at the factory to 9.7
km/h (6 MPH). It can be increased or decreased by
adjusting the speed stop screw (Figure 22).
Figure 22
1. Speed stop screw
4. Tilt steering lever
5. Indicator slot
6. Angle indicator
Tilt Steering Lever
Pull the tilt steering lever (Figure 21) back to tilt the steering
wheel to the desired position. Then push the lever forward
to tighten.
Indicator Slot
Models 30839, 30849 & 30807 only
The slot in the operator platform (Figure 21) indicates when
the cutting units are in the center position.
Angle Indicator
Models 30839, 30843 & 30807 only
The angle indicator (Figure 21) indicates the side hill angle of
the machine in degrees.
Ignition Switch
The ignition switch (Figure 23), used to start, stop, and
preheat the engine, has three positions: Off, On/Preheat, and
Start. Rotate the key to the On/Preheat position until the
glow plug indicator light goes out (approximately 7 seconds);
then rotate the key to the Start position to engage the starter
motor. Release the key when the engine starts. The key will
move automatically to the On/Run position. To shut the
engine off, rotate the key to the Off position. Remove the key
from the switch to prevent accidental starting.
1. Throttle
2. Hour meter
3. Temperature light
4. Oil pressure light
5. Glow plug indicator light
6. Alternator light
Throttle
Move the throttle (Figure 23) forward to increase the engine
speed and rearward to decrease the engine speed.
23
Figure 23
7. Cutting unit drive switch
8. Cutting unit shift lever
9. Ignition switch
10. Parking brake
11. Lift lever lock