Setup
Note: Determine the left and right sides of the machine from the normal operating position.
Loose Parts
Note: Use this chart as a checklist to ensure that all parts necessary for assembly have been received. Without these parts,
total setup cannot be completed.
Description
Locking hood switch
Lock washer
Nut
Key
Hood latch bracket
Capscrew, 1/4 x 3/4 in.
Flat washer, 1/4 in.
Locknut, 1/4 in.
Flange head capscrew, 5/16 x 5/8 in.
Flange head capscrew, 5/16 x 3/4 in.
Hydraulic filter (transmission)
CE decal
CE certificate
Service decal, blank
Diagnostic ACE display overlay
Video
Parts catalog
Operator's Manual (Traction Unit)
Engine Manual
Registration card
Connecting the Battery
Warning
Connecting cables to the wrong post could result in
personal injury and/or damage to the electrical
system.
Qty.
Use
1
1
1
2
Mounting locking hood latch for CE
1
2
2
2
1
Replacing floor panel fastener for CE
1
Securing access panel for CE
1
Change filter after first 10 hours of operation.
1
Affix to machine.
2
1
Affix to machine (International only).
Diagnosing machine (store in service shop until
1
needed)
1
View before operating the machine.
1
2
Read before operating the machine.
1
1
Fill out and return to Toro.
1. Open hood.
2. Ensure battery is securely fastened in place and check
battery charge with a hydrometer. If battery needs
charging, be sure at least one battery cable, preferable
the positive (+) cable, is disconnected from the battery
before connecting the charger (Fig. 1).
12