Toro 03540 Operator's Manual page 15

Figure 6
1. Carrier frame
5. Install a roll pin (Fig. 7) into hole in appropriate side of
each cutting unit carrier frame (Fig. 5).
Figure 7
1. Carrier frame
2. Roll pin
6. On the same side of carrier frame as roll pin is installed,
mount a basket bracket with a capscrew (5/16 x
1-3/4 in.), lock washer, flat washer, torsion spring,
basket collar, or fasteners previously removed, as
shown in Figure 7. Torsion springs are different for
left-hand and right-hand sides of carrier frames. There
are 2 left-hand and 3 right-hand springs. Longer leg of
spring is to be positioned forward as shown in Figure 8.
2. Basket guide
3. Basket bracket
4. Basket collar
15
Figure 8
1. Basket bracket
7. Align the mounting shaft of the cutting unit with the
pivot tube on the carrier frame. Insert the shaft into the
tube (Fig. 9).
Figure 9
1. Cutting unit mounting
shaft
2. Carrier frame pivot tube
3. Thrust washer
8. Secure shaft in pivot tube with a thrust washer, flat
washer, lock washer, and capscrew (Fig. 9).
9. Assemble the mounting nuts for the reel drive motor to
each cutting unit (Fig. 10). Leave approximately 1/2 in.
of threads exposed on each mounting stud.
2. Torsion spring
4. Flat washer
5. Lock washer
6. Capscrew