Fuses
There are 4 fuses in the machines electrical system. They
are located below control panel (Fig. 71 and 72).
Figure 71
1. Fuses
Figure 72
Optional Lighting
Important
If optional lighting is be added to the
traction unit, use the following schematic and part numbers
to prevent damage to the traction units electrical system.
Note: Make sure a good ground is achieved to prevent
damage to traction unit.
Backlapping the Cutting Units
Warning
Contact with the reels or other moving parts can
result in personal injury.
Keep fingers, hands, and clothing away from the
reels or other moving parts.
Never attempt to turn the reels by hand or foot
while the engine is running.
Note: When backlapping, the front units all operate
together, and the rear units operate together.
1. Position the machine on a level surface, lower the
cutting units, stop the engine, engage the parking brake,
and move the Enable/Disable switch to disable position.
2. Unlock and raise the seat to expose controls.
3. Make initial reel to bedknife adjustments appropriate
for backlapping on all cutting units which are to be
backlapped.
4. Start engine and run at idle speed.
45