Cleaning And Storage - Toro Dingo 320-D Operator's Manual

Compact utility loader with ce kit 22360 installed
Hide thumbs Also See for Dingo 320-D:
Table of Contents

Advertisement

3. Shut off the fuel valve on the bottom of the fuel tank
(Fig. 33).
1
Figure 33
1. Fuel valve
4. Open the rear access cover; refer to Opening the Rear
Access Cover, page 25.
5. Loosen the hose clamp at the fuel filter and slide it up
the fuel line away from the filter.
6. Pull the fuel line off of the fuel filter, open the fuel
valves, and allow the fuel to drain into a fuel can or
drain pan.
Note: Now is the best time to install a new fuel filter
because the fuel tank is empty.
7. Install the fuel line onto the fuel filter.
8. Slide the hose clamp close to the fuel filter to secure
the fuel line.
9. Close the rear access cover.
10. Open the fuel valve on the bottom of the fuel tank.

Cleaning and Storage

1. Lower the loader arms and stop the engine. Remove
the key.
2. Remove dirt and grime from the external parts of the
entire traction unit, especially the engine. Clean dirt
and chaff from the outside of the engine.
Important
detergent and water. Do not pressure wash the traction
m–4390
unit. Avoid excessive use of water, especially near the
control panel, engine, hydraulic pumps, and motors.
3. Service the air cleaner; refer to Servicing the Air
Cleaner, page 25.
4. Grease the traction unit; refer to Greasing the Traction
Unit, page 25.
5. Change the crankcase oil; refer to Servicing the
Engine Oil, page 26.
6. Check the tire pressure; refer to Tire Pressure, page 15.
7. Charge the battery; refer to Servicing the Battery, page
27.
8. Flush the fuel tank with fresh, clean diesel fuel
9. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged.
10. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
11. Check anti-freeze protection and fill the radiator with
a 50/50 solution of water and permanent ethylene
glycol anti-freeze.
12. Store the traction unit in a clean, dry garage or storage
area. Remove the key from the ignition switch and
keep it in a memorable place.
13. Cover the traction unit to protect it and keep it clean.
31
You can wash the traction unit with mild

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

22303

Table of Contents