Cleaning And Storage - Toro 22302TE Operator's Manual

2. Remove the filler caps from the battery and
connect a 3 to 4 amp battery charger to the
battery posts. Charge the battery at a rate of 4
amperes or less for 4 hours (12 volts). Do not
overcharge the battery.
3. Install the filler caps after the battery is fully
charged.
POTENTIAL HAZARD
Charging the battery produces gasses.
WHAT CAN HAPPEN
Battery gasses can explode.
HOW TO AVOID THE HAZARD
Keep cigarettes, sparks, and flames away
from the battery.

Cleaning and Storage

1. Lower the loader arms and stop the engine.
Remove the key.
2. Remove dirt and grime from the external parts of
the entire traction unit, especially the engine.
Clean dirt and chaff from the outside of the
engine.
IMPORTANT: You can wash the traction unit
with mild detergent and water. Do not
pressure wash the traction unit. Avoid
excessive use of water, especially near the
control panel, engine, hydraulic pumps and
motors.
3. Service the air cleaner; refer to Servicing the Air
Cleaner, page 24.
4. Grease the traction unit; refer to Greasing and
Lubrication, page 27.
5. Change the crankcase oil; refer to Servicing the
Engine Oil, page 25.
6. Change the hydraulic fluid; refer to Servicing the
Hydraulic System, page 29.
7. Check the tire pressure; refer to Tire Pressure,
page 14.
8. Charge the battery; refer to Servicing the Battery
page 32.
9. Flush the fuel tank with fresh, clean diesel fuel
10. Check and tighten all bolts, nuts, and screws.
Repair or replace any part that is damaged.
11. Check anti–freeze protection and fill the radiator
with a 50/50 solution of water and permanent
ethylene glycol anti–freeze.
12. Paint all scratched or bare metal surfaces. Paint
is available from your Authorized Service
Dealer.
13. Store the traction unit in a clean, dry garage or
storage area. Remove the key from the ignition
switch and keep it in a memorable place.
14. Cover the traction unit to protect it and keep it
clean.
Maintenance
33