Driving Forward Or Backward; Stopping The Traction Unit; Moving A Non Functioning Traction Unit - Toro 22302TE Operator's Manual

5. After the engine starts, move the throttle lever to
the desired setting.
IMPORTANT: Do not use starting fluid or
other chemicals to improve starting
performance.
Stopping the Engine
1. Move the throttle lever to the slow (turtle)
position.
2. Lower the loader arms to the ground.
3. Turn the ignition key off.
Note: If the engine has been working hard or
is hot, let it idle for a minute before
stopping the engine. This helps cool
the engine before it is stopped. In an
emergency, the engine may be stopped
immediately.

Driving Forward or Backward

To drive the traction unit, complete the following
actions as necessary:
To move forward, slowly push the traction
control levers forward.
To move rearward, slowly pull the traction
control levers rearward.
To go straight, apply equal pressure to both
traction control levers.
To turn, decrease pressure on the traction control
lever toward the direction you want to turn.
To slow or stop, move the traction control levers
to neutral.
Note: The farther you move the traction
control levers in either direction, the
faster the traction unit will move in
that direction.

Stopping the Traction Unit

To stop the traction unit, move the traction control
levers to neutral, lower loader arms to the ground,
and stop the engine. Remove the key.
POTENTIAL HAZARD
Someone could move or attempt to operate
the traction unit while it is unattended.
WHAT CAN HAPPEN
Children or bystanders may be injured if
they use the traction unit.
HOW TO AVOID THE HAZARD
Always remove the ignition key when
leaving the traction unit, even if just for a
few minutes.
Moving a Non Functioning
Traction Unit
IMPORTANT: Never tow the traction unit
without disconnecting the traction drive
chains because hydraulic damage may occur.
To Tow the Traction Unit
1. Stop the engine.
2. Remove the traction drive chains secured to front
and rear wheels.
3. Lift the rear wheels off of the ground and then
tow or push the traction unit.
To Lift the Traction Unit
1. Stop the engine.
2. Lift entire traction unit off of the ground
(attaching the lift chains to the two holes in the
frame located just above the attachment point of
the loader arms) and move it.
Operation
19