Greasing And Lubrication; Fuel Filter - Toro 22302TE Operator's Manual

1. Park the traction unit on a level surface, lower
the loader arms, and stop the engine. Remove
the key.
2. Allow the engine and radiator to cool, then
remove the radiator cap (Fig. 19).
1
Figure 19
1. Radiator cap
3. Open both coolant drain valves at the bottom of
the radiator and allow coolant to flow into a
drain pan.
Note: If you wish, you can attach a 3/8" ID
hose to each of the two drain valves.
4. When the coolant stops flowing, close the drain
valves.
5. Slowly fill the radiator with 0.8 gal. (3.1 l) of a
50/50 mixture of water and permanent ethylene
glycol anti–freeze.
6. Install the radiator cap.
7. Start the engine and operate it until it is warm.
Recheck the coolant level after the engine has
cooled down and replenish if required; refer to
Checking the Cooling System, page 14.
8. Dispose of engine coolant properly, according to
local laws and codes and keep it away from
children and animals.

Greasing and Lubrication

Grease all bearings, bushings, and pivot joints every
8 operating hours. Grease more frequently when
operating conditions are extremely dusty or sandy and
immediately after every washing.
Grease Type: General-purpose grease.
Greasing the Traction Unit
1. Lower the loader arms and stop the engine.
Remove the key.
2. Clean the grease fittings with a rag. Make sure to
scrape any paint off the front of the fitting(s).
3. Connect a grease gun to each fitting. Pump
grease into the fittings until grease begins to
ooze out of the bearings.
4. Wipe up any excess grease.
Lubricating Traction Drive Chain
1. Lower the loader arms and stop the engine.
Remove the key.
2. Apply a general purpose oil (10W30) onto upper
and lower chain spans.
3. Start the traction unit and slowly move it
forward to expose un-lubed upper and lower
chain spans.
4. Stop the engine and remove the key.
5. Apply oil to newly exposed un-lubed chain
spans.

Fuel Filter

Replace the fuel filter after every 400 operating hours
or yearly, whichever occurs first.
Replacing the Fuel Filter
Never re–install a dirty filter.
Maintenance
27