Table of Contents
Advertisement
Adjusting the Motion Control
Neutral Lock Pivot
The flanged nut can be adjusted to obtain a more desired
motion control lever resistance when moving it to the neutral
lock position. See Figure 85 for adjustment options.
1. Loosen the jam nut.
2. Tighten or loosen the flanged nut to the desired feel.
For more resistance, tighten the flanged nut.
For less resistance, loosen the flanged nut
3. Tighten the jam nut.
Figure 85
1. Flanged nut
2. Jam nut
Hydraulic System
Maintenance
Servicing the Hydraulic
System
Hydraulic Oil Type: Toro
or Mobil
®
1 15W-50.
Important: Use the oil specified. Other fluids could
cause system damage.
Each Hydraulic System Oil Capacity: 52 ounces (1.5 L)
per side with filter change
Checking the Hydraulic Oil
Service Interval: Every 50 hours—Check the hydraulic oil
level.
1. Position the machine on a level surface.
2. Disengage the PTO, move the motion control levers to
the neutral locked position, and set the parking brake.
3. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
4. Allow the engine and hydraulic system to cool for ten
minutes.
Note: The oil level on the dipstick will be incorrect
when the oil is checked and the unit is hot.
5. Move the seat forward.
6. Clean the area around the dipsticks of hydraulic system
reservoirs (Figure 86).
7. Remove one dipstick from the hydraulic reservoir
(Figure 86).
8. Wipe the dipstick off and thread the dipstick into the
reservoir.
9. Remove the dipstick and look at the end (Figure 86).
If the oil level is at the add mark , slowly pour only
enough oil into the hydraulic reservoir to raise the level
to the full or H line.
Important: Do not overfill the hydraulic units
with oil as damage may occur. Do not run the
machine with the oil below the add mark.
10. Install the dipstick.
11. Repeat the procedure for the opposite dipstick.
53
®
HYPR-OIL
™
500 hydraulic oil
Advertisement
Table of Contents
