Re-Install The Full Bed (Model 07212 Only) - Toro 07211TC Operator's Manual

1. Bed mounting plate
2. Cylinder rod end
3. Clevis pin
4. Lynch pin
5. Rear slots (Full bed)
6. Front slots ( 2 ⁄ bed)
3
1. Left rear corner of bed
2. Vehicle frame channel
3. Pivot plate
4. Clevis pin
5. Lynch pin
3. Remove the clevis pins securing the cylinder rod
ends to the bed mounting plates by pushing the
pins toward the inside (Fig. 10).
4. Remove the lynch pins and clevis pins securing
the pivot brackets to the frame channels
(Fig. 10).
5. Lift the bed off the vehicle.
Figure 9
Figure 10
CAUTION: The full bed weighs approximately
78 Kg, so don't try to install or remove it by
yourself. Get two or three other people to help.
6. Store cylinders in storage clips. Engage the
hydraulic lift lock lever on the vehicle to prevent
accidental extension of the lift cylinders.
Re-install the Full Bed
(Model 07212 only)
Note : If the bed sides will be installed on the flat bed,
it is easier to install them before the bed is installed on
vehicle.
Note : Assure rear pivot plates are bolted to the bed
frame/channel so that lower end angles to the rear
(Fig. 10).
1. Spacer bracket
2. Wear block
1. Assure the lift cylinders are fully retracted.
CAUTION: The full bed weighs approximately
78 Kg, so do not try to install or remove it by
yourself. Get the help of two or three other
people.
2. Carefully set the bed onto the vehicle frame
aligning the rear bed pivot plate holes with the
holes in the rear frame channel and install (2)
clevis pins and lynch pins (Fig. 10).
3. With the bed lowered, secure each cylinder rod
end to the appropriate slots in the bed mounting
plates with a clevis pin and a lynch pin. Insert the
clevis pin from the outside of the bed with the
lynch pin toward outside (Fig. 10). Rear slots are
16
Figure 11