Table of Contents
Advertisement
Check the Cooling System
(Fig. 17)
Capacity of cooling system is approximately 3.3 l
(3.5 qts.).
The cooling system is filled with a 50/50 solution of
water and permanent ethylene glycol anti-freeze.
Check level of coolant at beginning of each day before
starting the engine.
1.
Park machine on a level surface.
CAUTION
If engine has been running, pressurized hot
coolant can escape if radiator cap is removed
and cause burns. Allow engine to cool at least
15 minutes or until the radiator cap is cool
enough to touch without burning hand.
2.
Check coolant level. Coolant should be up to
COLD line on reserve tank, when engine is cold.
3.
If coolant is low, remove reserve tank cap and add
a 50/50 mixture of water and permanent ethylene
glycol anti-freeze. DO NOT OVERFILL.
4.
Install reserve tank cap.
3
2
1. Reserve tank
2. Cold line
3. Hot line
Check Hydraulic Fluid (Fig. 18)
The transaxle reservoir is filled with Dexron III ATF.
Check level before engine is first started and every 8
hours or daily, thereafter. Capacity of system is 7.1 l
(7.5 qts.).
1.
Position the vehicle on a level surface.
2.
Clean area around dipstick.
3.
Unscrew dipstick from top of transaxle and wipe
it with a clean cloth.
1. Dip stick
4.
Screw dipstick into transaxle and make sure it is
seated fully. Unscrew dipstick and check fluid
level. Fluid should be up to top of flat portion of
dipstick. If level is low, add enough fluid to
achieve the proper level.
20
Figure 17
1
Figure 18
1
Advertisement
Table of Contents
