Mounting The Front Carrier Frames; Adjusting The Carrier Frame Rollers; Optional Oil Cooler - Toro 04384 Operator's Manual

6
Mounting the Front Carrier
Frames
Parts needed for this procedure:
2 Carrier frame
2
Spacer
2 Bolt (1/2 inch x 3-1/4 inch)
2 Locknut (1/2 inch)
Procedure
1. Mount a carrier frame assembly to each clevis with a
spacer, 1/2 x 3-1/4 inch bolt and 1/2 inch locknut
(Figure 8). Torque to 91–113 N-m (67–83 ft/lb).
1. Carrier frame
2. Spacer
3. Clevis
2. Lubricate the bushings in each carrier frame with No.
2 Lithium Based grease.
Figure 8
4. Bolt (1/2 x 3-1/4 inch)
5. Locknut, 1/2 inch
7
Adjusting the Carrier Frame
Rollers
No Parts Required
Procedure
1. Position the machine on a level surface and lower the
cutting unit carrier frames to the floor.
2. Verify that there is 13 mm (1/2 inches) clearance
between the carrier frame rollers and the floor.
3. If an adjustment is required, loosen the jam nut on the
carrier frame stop screw (Figure 9) and rotate the screw
up or down to raise or lower the carrier frame. Tighten
the jam nut after adjustment is attained.
1. Carrier frame roller
8

Optional Oil Cooler

No Parts Required
Procedure
If you are operating the machine in hot climates, where
ambient temperatures range from 20° C (70° F) to 49° C
16
Figure 9
2. Carrier frame stop screw