Adjusting The Transport Height - Toro 04384 Operator's Manual

counterclockwise until the flanges are encircling the
studs (Figure 11).
9. Tighten the mounting bolts (Figure 11).
10

Adjusting the Transport Height

No Parts Required
Procedure
Check the transport height (Figure 13 & Figure 14) and
adjust, if required.
1. Position the tractor on a level surface.
2. On cutting units equipped with a offset lift hook
(Figure 12, inset) verify that the distance from the top
of the carrier frame adjusting screw to the back of the
carrier frame is 25 mm (1 inch). If the distance is not
25 mm (1 inch), proceed to step 4.
1. Transport plate
2. Adjusting screw
3. Transport plate mounting
screw
3. On cutting units equipped with a chain link or a straight
lift hook (Figure 13 & Figure 14, insets) verify that the
distance from the top of the carrier frame adjusting
screw to the back of the carrier frame is 22 mm (7/8
inch). If the distance is not 22 mm (7/8 inch), proceed
to step 4. If the cutting unit is equipped with an offset
lift link (Figure 12), proceed to the next step.
Figure 12
4. Offset lift hook
5. 25 mm (1 inch)
1. Transport plate
2. Adjusting screw
3. Transport plate mounting
screw
1. Transport plate
2. Adjusting screw
3. Transport plate mounting
screw
4. Loosen the transport plate mounting screws (Figure 13,
Figure 14 and Figure 12).
5. Raise the cutting units to the transport position.
Important: Do not raise the suspension to the
transport position when the reel motors are in the
holders in the machine frame. Damage to the
motors or hoses could result.
6. Ensure each carrier frame is at the same height from
the ground. If they are, proceed to step 8.
7. If the carrier frames are not at the same height, loosen
the jam nut on the carrier frame adjusting screw
18
Figure 13
4. Chain link
5. 22 mm (7/8 inch)
Figure 14
4. Link hook
5. 22 mm (7/8 inch)