Adjusting The Transport Height - Toro 04383 Operator's Manual

counterclockwise until the flanges are encircling the
studs (Figure 18).
13. Tighten the mounting bolts (Figure 18).
9

Adjusting the Transport Height

No Parts Required
Procedure
Check the transport height (Figure 19 & Figure 20) and
adjust, if required.
1. Position the tractor on a level surface.
2. On cutting units equipped with a chain link or a straight
lift hook (Figure 19 & Figure 20, insets) verify that the
distance from the top of the carrier frame adjusting
screw to the back of the carrier frame is 7/8 inch (22
mm). If the distance is not 7/8 inch (22 mm), proceed
to step 4. If the cutting unit is equipped with an offset
lift link (Figure 21), proceed to the next step.
1. Transport plate
2. Adjusting screw
3. Transport plate mounting
screw
Figure 19
4. Chain link
5. 7/8 inch (22 mm)
1. Transport plate
2. Adjusting screw
3. Transport plate mounting
screw
3. On cutting units equipped with a offset lift hook
(Figure 21, inset) verify that the distance from the top
of the carrier frame adjusting screw to the back of the
carrier frame is 1 inch (25 mm). If the distance is not
1 inch (22 mm), proceed to step 4.
1. Transport plate
2. Adjusting screw
3. Transport plate mounting
screw
4. Loosen the transport plate mounting screws (Figure 19,
Figure 20 and Figure 21).
5. Raise the cutting units to the transport position.
Important: Do not raise the suspension to the
transport position when the reel motors are in the
20
Figure 20
4. Link hook
5. 7/8 inch (22 mm)
Figure 21
4. Offset lift hook
5. 1 inch (25 mm)