Installing The Rear Wheel; Mounting The Seat - Toro 04383 Operator's Manual

Note: Mounting fasteners for the Greensmaster 3250-D
cutting units are included with the cutting units.
1

Installing the Rear Wheel

Parts needed for this procedure:
1 Wheel hub
4 Wheel nuts
1 Wheel
1 Wheel bolt
1 Locknut
2 Spacers
Procedure
1. Mount the wheel hub to the rear wheel rim with 4
mounting nuts (Figure 3). Torque the nuts to 70–90
ft.-lb.
2. Remove the wheel bolt and locknut from the wheel
mounting holes in the rear castor fork (Figure 3).
3. Install the rear wheel into the castor fork. Insert the
wheel bolt into one of the castor fork mounting holes,
install a spacer (supplied in loose parts), and slide the
bolt through the wheel.
4. Install another spacer onto the bolt and route the bolt
through the remaining castor fork mounting hole.
5. Position the bend of the wheel bolt head under the
bottom edge of the adapter plate (Figure 3). Install and
tighten the locknut to secure the wheel to the castor
fork. Do not overtighten the locknut as the wheel must
rotate freely.
1. Rear wheel
2. Hub
3. Nut
6. Wipe the grease fitting clean on the wheel assembly.
Pump grease into the wheel hub until grease is seen
exiting at both hub bearings. Wipe up excess grease.
2

Mounting the Seat

Parts needed for this procedure:
1 Seat
4 Nut (5/16 inch)
Procedure
Note: Mount the seat slides in the front set of mounting
holes to gain an additional 3 in. (7.6 cm) in the forward
adjustment, or in the rear mounting holes for an additional 3
in. (7.6 cm) in the rearward adjustment.
1. Remove the locknuts securing the seat slides to the
plywood shipping base. Discard the locknuts.
2. Connect the wire harness to the seat switch.
3. Secure the seat, seat panel, and seat slides to the seat
support with the locknuts (5/16 in.) (Figure 4) supplied
in the loose parts.
13
Figure 3
4. Rear castor fork
5. Wheel bolt
6. Spacer (2)