Drive System Maintenance; Adjusting The Transmission For Neutral; Adjusting The Transport Speed; Adjusting The Mowing Speed - Toro 04383 Operator's Manual

Drive System
Maintenance
Adjusting the Transmission
for Neutral
If the machine creeps when the traction control pedal is in
the neutral position, the neutral return mechanism must be
adjusted.
1. Block up under the frame so that one of the front
wheels is off of the floor.
Note: Note: If machine is equipped with a 3 wheel
drive kit, also raise and block rear wheel.
2. Start the engine, move the throttle to Slow, and check
the front wheel that is off of the floor; it must not be
rotating.
3. If the wheel is rotating, stop the engine and proceed
as follows:
A. Loosen both jam nuts securing the traction
control cable to the bulkhead on the hydrostat
(Figure 49). Make sure the jam nuts are loosened
equally and sufficiently to allow adjustment.
B. Loosen the nut securing the eccentric to the top
of the hydrostat (Figure 49).
C. Move the functional control lever to Neutral and
the throttle to Slow. Start the engine.
D. Rotate the eccentric until creep does not occur in
either direction. When the wheel stops rotating,
tighten the nut locking the eccentric and the
adjustment (Figure 49). Verify the adjustment
with the throttle in the Slow and Fast position.
E. From each side of the bulkhead, tighten the
locknuts evenly, securing the traction cable to the
bulkhead (Figure 49). Do not twist the cable.
Note: If cable tension exists when the functional
control lever is in neutral, the machine may creep
when the lever is moved to the Mow or Transport
position.
1. Traction cable
2. Bulkhead
3. Jam nuts

Adjusting the Transport Speed

The traction pedal is adjusted for maximum transport speed
at the factory, but an adjustment may be required if the pedal
reaches full stroke before it contacts the pedal stop, or if a
decrease in transport speed is desired.
Press down on the traction pedal. If the pedal contacts
the stop (Figure 50) before tension is felt on the cable, an
adjustment is required:
1. Pedal stop
1. Loosen flangehead locknuts securing the pedal stop to
the floor plate (Figure 50).
2. Adjust the pedal stop so it contacts the pedal rod and
tighten the nuts.

Adjusting the Mowing Speed

The machine is adjusted at the factory, but speed may be
varied if desired.
1. Loosen the jam nut on the trunnion bolt (Figure 51).
2. Loosen the nut securing the lock and mow brackets
on the pedal pivot.
41
Figure 49
4. Eccentric
5. Locknut
Figure 50