Toro 04383 Operator's Manual page 18

Figure 11
1. Prop (not provided)
1. Remove the cutting units from the cartons. Assemble
and adjust them as listed in the cutting unit Operator's
Manual. Use the gauge bar from the loose parts kit to
adjust the height of cut.
2. Install the offset lift hook (Figure 12) to the top of the
cutting unit with (2) M10–1.5 bolts. Torque the bolts
to 25–30 ft–lbs. (34–40 N⋅m). The offset lift hook
should be positioned with hook forward.
Figure 12
1. Offset lift hook
3. All cutting units are shipped with the counter weight
mounted to the left end and the motor mount and drive
coupler mounted to the right end of the cutting unit.
To mount the cutting unit in the right front position,
proceed as follows:
A. Remove the 2 bolts securing the counter weight
to the left end of the cutting unit. Remove the
counter weight (Figure 13).
2. Bedknife adjusting screw
nut (2)
1. Counter weight
B. On right end of cutting unit, remove plastic plug
from bearing housing (Figure 14).
Note: Retain the protective covers for the cutting
units. Install them whenever the reel drive motors
are removed to protect the cutting unit bearings
from contamination.
C. Remove the 2 allen head screws securing the
motor mount to the right end of the cutting unit.
Remove the motor mount (Figure 14).
1. Motor mount
2. Plastic plug
D. Remove the snap ring securing the drive coupler
in the reel tube (Figure 15). Remove the drive
coupler.
18
Figure 13
Figure 14
3. Allen head screw (2)