Toro 04383 Operator's Manual page 19

Figure 15
1. Snap ring
E. Apply grease to the inside diameter of the drive
coupler. Install the drive coupler to the left end of
the cutting unit reel tube with a snap ring.
F. Install the motor mount to the left end of
the cutting unit with the (2) allen head screws
previously removed. Torque screws to 12–15
ft–lbs. (16–20 N⋅m).
G. Install the counter weight to the right end of the
cutting unit with the screws previously removed.
4. The cutting unit is shipped without a front roller.
Obtain a roller (Model No. 04625, 04626 or 04627)
from your local Toro Distributor. Install the roller
using the loose parts supplied with the cutting unit and
installation instructions included with the roller.
5. Thread a ball stud into each end of the cutting unit
front roller (Figure 16).
Figure 16
1. Ball stud
6. Slide the cutting unit under the pull frame while
hooking the lift hoop onto the lift arm.
7. Slide the sleeve back on each ball joint receiver and
hook the receiver onto the cutting unit ball stud
(Figure 17).
2. Drive coupler
1. Pull link extension
2. Pull arm
8. Mount the basket onto the carrier frame.
9. Adjust the pull links until there is 1/16 to 1/8 in. (2 to
3 mm) clearance between the lip of the basket and the
reel blades. Make sure the basket lips are equidistant
from the reel blades all the way across the reel blades.
10. Assemble the mounting screws for the reel drive motor
to each cutting unit. Leave approximately 1/2 in. (13
mm) of the threads exposed on each mounting screw
(Figure 18).
1. Screws
11. Using a hand pump grease gun, fill the cavity at the end
of the cutting unit with #2 general purpose grease.
12. Coat the spline shaft of the motor with clean grease
and install the motor by rotating the motor clockwise
so the motor flanges clear the studs. Rotate the motor
19
Figure 17
3. Ball joint receiver
Figure 18
2. Drive motor