Drive System Maintenance; Adjusting The Traction-Pedal Angle; Checking The Planetary-Drive Gear/Brake-Oil Level; Changing The Planetary-Drive Gear/Brake Oil - Toro Groundsmaster 5910 Operator's Manual

Drive System
Maintenance
Adjusting the Traction-Pedal
Angle
You can adjust the operating angle of the traction pedal for
your comfort.
1. Loosen the 2 nuts and bolts securing the left side of the
traction pedal to the bracket
Figure 71
1. Traction pedal
2. Pivot the pedal to the desired operating angle and
tighten the nuts (Figure
Checking the Planetary-Drive
Gear/Brake-Oil Level
Service Interval: Every 400 hours—Check the
planetary-drive gear/brake-oil level
(check if you observe external leakage).
Use high quality SAE 85W-140 gear lube as a replacement.
1. With the machine on a level surface, position the wheel
so that 1 check plug is at the 12 o'clock position and
the other is at the 3 o'clock position
(Figure 71).
2. Mounting nuts and bolts
71).
(Figure 72).
1. Check/drain plug (3 o'clock position)
2. Remove the plug at the 3 o'clock position
Note: The oil level should be within 6 mm (1/4 inch)
of the check-plug hole.
3. If the oil level is low, remove the plug at the 12 o'clock
position and add oil until it begins to flow out of the
hole at the 3 o'clock position.
4. Install both plugs.
5. Repeat steps 1 through
assembly.
Changing the Planetary-Drive
Gear/Brake Oil
Service Interval: After the first 250 hours—Change the
planetary-drive gear/brake oil.
Every 800 hours
Use a high quality SAE 85W-140 gear lube as replacement.
1. With machine on level surface, position a wheel so one
of the check/drain plugs is at the lowest (6 o'clock)
position (Figure
1. Check/drain plugs
2. Place a drain pan under the planetary hub, remove both
plugs, and allow oil to drain.
3. Place a drain pan under the brake housing, remove the
drain plug, and allow the oil to drain
50
g019500
Figure 72
(Figure
3 on the opposite planetary-gear
73).
1
G024792
Figure 73
(Figure
72).
74).