Installing The Front Wheels; Installing The Rear Wheel - Toro 04383 Greensmaster 3250-D Operator's Manual

Description
Anti-scalp roller
Pull link assembly
Roller shaft
Spacer
Washer
Lock nut, 3/8–16
Offset Lift Hook
Capscrews, M10–1.5
Grass Basket
Ignition key
Service decal
Operator's manual (traction unit)
Operator's manual (engine)
Operator video
Parts Catalog
Certificate of compliance
Pre-delivery sheet
Noise certificate
Note: Mounting fasteners for the Greensmaster 3250-D cutting units are included with the cutting units.

Installing the Front Wheels

Mount the front wheels and torque the mounting nuts to
70–90 ft.-lb.

Installing the Rear Wheel

1. Mount the wheel hub to the rear wheel rim with 4
mounting nuts (Fig. 2). Torque the nuts to 70–90 ft.-lb.
2. Remove the wheel bolt and locknut from the wheel
mounting holes in the rear castor fork (Fig. 2).
3. Install the rear wheel into the castor fork. Insert the
wheel bolt into one of the castor fork mounting holes,
install a spacer (supplied in loose parts), and slide the
bolt through the wheel.
4. Install another spacer onto the bolt and route the bolt
through the remaining castor fork mounting hole.
5. Position the bend of the wheel bolt head under the
bottom edge of the adapter plate (Fig. 2). Install and
tighten the locknut to secure the wheel to the castor
fork. Do not overtighten the locknut as the wheel must
rotate freely.
Qty. Use
6
6
6
Mount the front rollers
6
12
6
1 Mount to cutting unit Models 04610 & 04611.
Use to mount offset lift hook to cutting unit
2
Models 04610 & 04611.
3 Mount to the pull frame.
2
Affix appropriate language decal over English
11
service decal (100-3150).
2
Read before operating the machine.
1
1 Watch before operating the machine.
1
1
1
1
1
3
2
1. Rear wheel
2. Hub
3. Nut
6. Wipe the grease fitting clean on the wheel assembly.
Pump grease into the wheel hub until grease is seen
exiting at both hub bearings. Wipe up excess grease.
12
5
6
Figure 2
4. Rear castor fork
5. Wheel bolt
6. Spacer (2)
4