Operation; Think Safety First; Controls - Toro 04383 Greensmaster 3250-D Operator's Manual

Operation

Think Safety First

Please carefully read all the safety instructions on
pages 3 thru 7. Knowing this information could help you
and others avoid injury.
The use of protective equipment, such as, but not limited
to, for eyes, ears, feet, and head is recommended.
Caution
This machine produces sound levels in excess of
85dBA at the operators ear and can cause hearing
loss through extended periods of exposure.
Wear hearing protection when operating this
machine.

Controls

Traction Pedal
The traction pedal (Fig. 30) has three functions: to make
the machine move forward, to move it backward, and to
stop the machine. Depress the top of the pedal to move
forward and the bottom of the pedal to move backward or
to assist in stopping when moving forward. Also, allow the
pedal to move to the neutral position to stop the machine.
For operator comfort, do not rest the heel of your foot on
reverse when operating forward (Fig. 31).
2
3
Figure 30
1. Traction pedal
2. Brake pedal
1
3. Parking brake lever
24
Figure 31
Brake Pedal
The Brake Pedal (Fig. 30) actuates an automotive
drum-type mechanical brake located at each traction wheel.
Parking Brake Lever
Depressing the brake pedal to actuate the brake assembly,
then depressing the small lever indicated (Fig. 30) will keep
the brakes actuated for parking. Disengage the parking
brake by depressing the brake pedal. Lock the parking
brake any time you leave the machine.
Throttle Control
The throttle control (Fig. 32) gives the operator the ability
to control the speed of the engine. Moving the throttle
control toward the Fast position increases the engine RPM;
moving the throttle control toward Slow will decrease the
engine RPM. Ground speeds are as follows:
• 2 to 5 MPH (3.2 to 8 km/h) forward mowing speed
• 8.8 MPH (14.1 km/h) maximum transport speed
• 2.5 MPH (4.0 km/h) reverse speed
Functional Control Lever
The functional control lever (Fig. 32) provides two traction
selections plus a Neutral position. It is permissible to shift
from mow to transport or transport to mow (not to neutral)
while the machine is in motion. No damage will result.
• Rear Position—neutral and backlapping
• Middle Position—used for mowing operation
• Front Position—used for transport operation
Hour Meter
The hour meter (Fig. 32) indicates the total hours of
machine operation. The hour meter starts to function
whenever the key switch is rotated to On.