Installing The Steering Wheel - Toro 04383 Greensmaster 3250-D Operator's Manual

Note: After the battery has been activated, add only
distilled water to replace normal loss, although
maintenance–free batteries should not require water under
normal operating conditions.
Warning
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals
known to the State of California to cause cancer
and reproductive harm. Wash hands after
handling.
Warning
Battery terminals or metal tools could short
against metal tractor components causing sparks.
Sparks can cause the battery gasses to explode,
resulting in personal injury.
• When removing or installing the battery, do not
allow the battery terminals to touch any metal
parts of the tractor.
• Do not allow metal tools to short between the
battery terminals and metal parts of the tractor.
7. First, install the positive cable (red) to the positive (+)
terminal and then the negative cable (black) to the
negative (–) terminal of the battery and secure them
with the bolts and nuts (Fig. 6). Slide the rubber boot
over the positive terminal to prevent a possible short
from occurring.
Warning
Incorrect battery cable routing could damage the
tractor and cables causing sparks. Sparks can
cause the battery gasses to explode, resulting in
personal injury.
• Always disconnect the negative (black) battery
cable before disconnecting the positive (red)
cable.
• Always connect the positive (red) battery cable
before connecting the negative (black) cable.
1
1. Negative (–)

Installing the Steering Wheel

1. Slide the steering wheel onto the steering shaft.
3
1
1. Steering wheel
2. Jam nut
2. Secure the steering wheel to the shaft with the jam nut
(Fig. 7) and tighten it to 20–26 ft.-lb.
3. Install the cap to the steering wheel with the screw
(Fig. 7).
14
2
Figure 6
2. Positive (+)
2
Figure 7
3. Cap