Oil Pressure Light; Ignition Switch - Toro 04383 Greensmaster 3250-D Operator's Manual

5
4
7
6
9
8
Figure 32
1. Throttle control
2. Functional control lever
3. Hour meter

4. Ignition switch

5. Steering arm locking lever
6. Water temperature light
Ignition Switch
Insert the key into the switch (Fig. 32) and rotate it
clockwise as far as possible to the Start position to start the
engine. Release the key as soon as the engine starts; the key
will move to the On position. Rotate the key
counterclockwise to the Off position to stop the engine.
Steering Arm Locking Lever
Rotate the lever (Fig. 32) rearward to loosen the
adjustment, raise or lower the steering arm for operator
comfort, then, rotate the lever forward to tighten the
adjustment.
Water Temperature Light
The light (Fig. 32) glows and the engine automatically
shuts down when the engine coolant temperature gets too
high.
High Temperature Override Button
If the engine kills due to an overheating condition, press the
override button (Fig. 32) in and hold it until the machine
can be moved to a safe location and allowed to cool down.
Note: When using the override button, it must be held
down continuously to operate. Do not use it for extended
periods of time.
3 11
2
1
10
7. Engine oil pressure light
8. Battery warning light
9. Glow plug light
10. Raise/Lower Mow Control
11. High temperature override
button
25
Glow Plug Indicator Light
When the glow plug indicator light (Fig. 32) is lit, it
indicates the glow plugs are on.
Battery Warning Light
The light (Fig. 32) glows if the battery charge is low.

Oil Pressure Light

The light (Fig. 32) glows if the engine oil pressure drops
below a safe level.
Raise/Lower Mow Control
Moving the control (Fig. 32) forward during operation
lowers the cutting units and starts the reels. Pull back on the
control to stop the reels and raise the cutting units. During
operation the reels can be stopped by pulling back on the
control momentarily and releasing it. Restart the reels by
moving the control forward.
Backlap Lever
Use the backlap lever (Fig. 33) in conjunction with the
lower mow/raise control lever for backlapping the reels.
2
Figure 33
1. Backlap lever
Reel Speed Control
Use the reel speed control (Fig. 33) to adjust the RPM of
the reels.
Seat Adjusting Lever
The seat adjusting lever on the left side of the seat (Fig. 34)
allows a 7 in. ( cm) fore and aft adjustment.
1
2. Reel speed control