Installing The Rear Wheel Assembly; Mounting The Seat; Installing The Battery - Toro 04356 Operator's Manual

Installing the Rear Wheel
Assembly
1. Remove the bolt and locknut from the wheel mount
holes in the rear castor fork (Fig. 4).
2. Install the rear wheel in the castor fork. Insert the bolt
into one of the mounting holes, install a spacer, and
slide the bolt through the wheel (Fig. 4).
2
Figure 4
1. Bolt
2. Spacer
3. Install another spacer onto the bolt and route the bolt
through the remaining castor fork mounting hole.
4. Position the bend of the bolt head under the bottom
edge of the castor fork. Install and tighten the locknut to
secure the wheel to the castor fork (Fig. 5).
5. Wipe the grease fitting clean on the wheel assembly.
Pump grease into the wheel hub until grease is seen
exiting at both hub bearings, thus ensuring the wheel
hub cavity is full. Wipe up any excess grease.
Figure 5
1
3
3. Locknut
13

Mounting the Seat

Note: Mount the seat slides in the front set of mounting
holes to gain an additional 3 in. (7.6 cm) in the forward
adjustment, or in the rear mounting holes for an additional
3 in. (7.6 cm) in the rearward adjustment.
1. Support the seat base in the up position with the seat
support rod.
2. Remove the locknuts securing the seat slides to the
plywood shipping base. Discard the locknuts.
3. Secure the seat, seat panel, and seat slides to the seat
support with the locknuts (5/16 in.) (Fig. 6) supplied in
the loose parts. Mount the seat panel on the right side,
positioned as shown in Figure 6.
2
1
Figure 6
1. Seat support rod
2. Seat slide

Installing the Battery

1. Mount the battery with the battery terminals toward the
hydraulic tank.
Warning
Battery terminals or metal tools could short
against metal tractor components causing sparks.
Sparks can cause the battery gasses to explode,
resulting in personal injury.
• When removing or installing the battery, do not
allow the battery terminals to touch any metal
parts of the tractor.
• Do not allow metal tools to short between the
battery terminals and metal parts of the tractor.
3
3. Seat panel