Toro 04356 Operator's Manual page 44

Problem
The engine fails to crank, regardless of
the shift selector or mow pedal
position.
The engine cranks but does not start
when the shift selector and mow pedal
are in neutral.
The engine does not stop when the
mow pedal is depressed (the reels are
engaged) as you get off of the seat. g g ) y g
The engine does not stop when the
shift selector is in gear as you get off
of the seat.
Possible Causes
1. The mow/lift switch, traction switch,
and/or seat switch are adjusted
incorrectly or are damaged.
2. The battery terminals are corroded.
3. The mow/lift or traction switch
wires are loose.
4. The battery is dead.
5. A solenoid is damaged.
6. The ignition switch is damaged.
7. The starter is damaged.
8. The engine is seized.
9. The key switch, voltmeter, or
solenoid wires are loose.
10. The operator is not on the seat.
1. The cause of this problem is
unrelated to the interlock wiring
system.
2. The rear camshaft is misadjusted.
3. The engine or rectifier plug is
loose.
4. The "I" terminal wire of key switch
is loose.
5. There is engine trouble or the fuel
tank is empty.
6. The parking brake kill relay is
damaged.
1. The mow/lift or seat switch is
adjusted incorrectly or is damaged.
2. The seat return pin spring is
broken, missing, or jammed down.
3. The seat pivot fails to rotate freely.
1. The traction or seat switch is
adjusted incorrectly or is damaged.
2. The seat return pin spring is
broken, missing, or jammed down.
3. The seat pivot fails to rotate freely.
44
Corrective Action
1. Refer to Replacing the Traction
Switch, Replacing the Mow/Lift
Switch, and/or Replacing the Seat
Switch.
2. Clean the terminals.
3. Check the wires and connect them
properly.
4. Charge or replace the battery.
5. Replace the solenoid.
6. Replace the ignition switch.
7. Replace or repair the starter.
8. Repair the engine.
9. Connect the wires.
10. Sit on the seat.
1. All interlock switches are okay.
Proceed to next cause.
2. Adjust the camshaft.
3. Connect the wire.
4. Connect the wire.
5. Determine the problem and correct
it.
6. Replace the relay.
1. Refer to Replacing the Mow/Lift
Switch or Replacing the Seat
Switch.
2. Replace, loosen, and lubricate the
parts so that the pin operates
freely.
3. Loosen and lubricate the seat pivot
pin to ensure free movement.
1. Refer to Replacing the Traction
Switch or Replacing the Seat
Switch.
2. Replace, loosen, and lubricate the
parts sp that the pin operates
freely.
3. Loosen and lubricate the seat pivot
pin the ensure free movement.