Installing The Cutting Units - Toro 04384 Operator's Manual

(120° F), or using it for heavy-duty use (mowing other than
greens, such as fairways or verticutting), install a Hydraulic
Oil Cooler Kit, Part No. 104–7701, to the machine.
9

Installing the Cutting Units

Parts needed for this procedure:
Offset lift hook (Refer to the Cutting Unit Operators
3
Manual for the Installation Instructions)
6 Screw (supplied with the cutting unit)
1 Bolt (#10 x 5/8 inch)
1 Jam nut (#10)
3 Cutting unit (sold separately)
6 Ball stud (supplied with the cutting unit)
3 Grass Basket
Procedure
Note: When sharpening, setting the height-of-cut or
performing other maintenance procedures on the cutting
units, store the cutting unit reel motors in the support tubes
to prevent damage to the hoses.
Important: Do not raise the suspension to the transport
position when the reel motors are in the holders in the
machine frame. Damage to the motors or hoses could
result
1. Remove the cutting units from the cartons. Assemble
and adjust them as listed in the cutting unit Operator's
Manual.
2. Slide the cutting unit under the pull frame while
hooking the lift hoop onto the lift arm.
3. Slide the sleeve back on each ball joint receiver and
hook the receiver onto the cutting unit ball stud
(Figure 10).
2
1. Pull link extension
2. Pull arm
4. Mount the basket onto the carrier frame.
5. Adjust the pull links until there is 2 to 3 mm (1/16 to
1/8 inch) clearance between the lip of the basket and
the reel blades. Make sure the basket lips are equidistant
from the reel blades all the way across the reel blades.
6. Align the sockets in the ball joints so the open side of
the socket is centered towards the ball stud. Tighten
the jam nuts to secure the sockets in position.
7. Ensure that there is approximately 13 mm (1/2 inch) of
the threads exposed on each reel drive motor mounting
bolt (Figure 11).
1. Mounting bolts
8. Coat the spline shaft of the motor with clean grease
and install the motor by rotating the motor clockwise
so the motor flanges clear the studs. Rotate the motor
17
1
g021274
Figure 10
3. Ball joint receiver
Figure 11
2. Drive motor
3