Assembly; Loose Parts; Installing The Valve Lever; Activating The Battery - Toro 22304 Operator's Manual

Assembly

Loose Parts

Note: Use the chart below to verify all parts have been shipped.
DESCRIPTION
Valve Lever
Key
Oil filter
Chain link

Installing the Valve Lever

1. Thread the lever into the pump selector valve
(Fig. 1).
Note: The lever should be installed with the
bend toward the operator.
2. Tighten the jam nut on the lever to lock it in
position.
1
Figure 1
1. Pump selector lever
8
QTY.
1 Install valve lever
2 Start the engine
1 Break–in oil change
2 Spare parts

Activating the Battery

The traction unit is shipped with a dry battery.
Purchase bulk electrolyte with 1.260 specific gravity
from a local battery supply outlet.
1. Remove the wing nut and bolt securing the
battery clamp and strip (under the clamp) and
remove the clamp and strip (Fig. 2).
m–3883
1. Battery
2. Battery clamp
3. Positive cable
USE
1
2
4
Figure 2
4. Rubber cover
5. Negative cable
5
3
m–3953