Electrical System Maintenance; Replacing The Fuses; Replacing The Headlights; Servicing The Battery - Toro 07264 Operator's Manual

2. Place a clean container under the fuel filter.
3. Remove the clamps securing the fuel filter to
the fuel lines (Figure 37).
Figure 37
1. Fuel lter
4. Install the replacement filter to the fuel lines
with the clamps previously removed.
Mount the filter so that the arrow points
toward the carburetor.
Electrical System
Maintenance

Replacing the Fuses

There are 3 fuses in the electrical system. They are
located beneath the bed in a box on the right hand
side of the frame (Figure 38).
Ignition System
Lights
Power Point
Figure 38
1. Ignition system
2. Lights

Replacing the Headlights

Specification: GE Headlight #H7610
1. Set the parking brake, turn the ignition off, and
remove the key.
10 amp.
10 amp.
10 amp. (15 amp. max.)
3. Power point
2. Reach beneath the dash and push the headlight
out of the hood.
3. Remove the screws attaching the wire harness
to the headlight.
4. Remove the rubber seal from around the
headlight (Figure 39). Discard the headlight.
Figure 39
1. Rubber seal
2. Inside notch-align with the
notch on the headlight
5. Align the notch on the inside of the seal with
the notch on the new headlight (Figure 39).
Slide the seal onto the headlight until the seal
is firmly in place.
6. Attach the headlight to the wire harness using
the previously removed screws.
7. Align the notch on the outside of the seal with
the notch in the hood. Push the headlight and
seal into the hood until it is firmly in place.
Note: Applying soapy water to the outside
of the seal may aid in sliding the seal into the
hood.

Servicing the Battery

Warning
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead
compounds, chemicals known to the State of
California to cause cancer and reproductive
harm. Wash hands after handling.
34
3. Outside notch-align with
notch in hood
4. Headlight