Toro 30410 Operator's Manual page 25

Figure 21
8. Remove the hairpin cotters and clevis pins securing
the damper links to the cutting unit brackets
(Figure 22). Align the damper link holes with the
selected height-of-cut bracket holes in the cutting
unit frame (Figure 23), insert the clevis pins, and
install the hairpin cotters.
Important: The damper link length should
never be adjusted. The length between the hole
centers should be 5-3/8 inch (13.7 cm).
Figure 22
1. Damper link
Adjusting the Skids
The skids should be mounted in the lower position
when operating in height of cuts greater than 2-1/2
inches (64 mm) and in the higher position when
operating in height of cuts lower than 2-1/2 inches (64
mm).
Adjust the skids by removing the flange bolt and nuts,
positioning them as desired, and installing the fasteners
(Figure 24).
1. Skid
Adjusting the Cutting Unit Rollers
The cutting unit rollers should be mounted in the lower
position when operating in height of cuts greater than
2-1/2 inches (64 mm) and in the higher position when
operating in height of cuts lower than 2-1/2 inches (64
mm).
1. Remove the bolt and nut securing the gage wheel to
the cutting unit brackets (Figure 25).
25
Figure 23
Figure 24