Specifications; Attachments/Accessories; Operation; Before Operating - Toro 30410 Operator's Manual

Temperature Override Switch
Press and hold the reset switch (Figure 4) to start the
engine after high temperature shut down. Use only for
emergency operation.
Audible Alarm
The alarm (Figure 4) is activated when the low engine
oil pressure light illuminates or the high coolant
temperature light illuminates.
Alarm Silence Switch
This switch (Figure 4) shuts off the audible alarm.

Specifications

Note: Specifications and design are subject to change without notice.
Width of cut
overall
front cutting unit
side cutting unit
front and one side cutting unit
Overall width
cutting units down
cutting units up (transports)
Overall length
Height
Height with ROPS
Ground clearance
Wheel tread (to center of tire)
front
rear
Wheel base
Weight (with cutting units and fluids)

Attachments/Accessories

A selection of Toro approved attachments and
accessories are available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
Throttle Control
Move the control (Figure 4) forward to increase the
engine speed and rearward to decrease the speed.
Power Point
The power point (Figure 4) is used to power optional
electrical accessories.

Operation

132 inch (335 cm)
Note: Determine the left and right sides of the
62 inch (157 cm)
machine from the normal operating position.
42 inch (107 cm)

Before Operating

97 inch (246 cm)
136 inch (345 cm)
72 inch (183 cm)
If you leave the key in the ignition switch,
135 inch (342 cm)
someone could accidently start the engine and
seriously injure you or other bystanders.
55 inch (140 cm)
Remove the key from the ignition before you do
81 inch (206 cm)
any maintenance.
6-1/2 inch (17 cm)
Checking the Engine Oil
45 inch (114 cm)
Service Interval: Before each use or daily
47 inch (119 cm)
The engine is shipped with oil in the crankcase;
however, the oil level must be checked before and after
55-1/2 in (141 cm)
the engine is first started.
3860 lb (1751 kg)
The crankcase capacity is 8 qt (7.6 l) with the filter.
Use high-quality engine oil that meets the following
specifications:
• API Classification Level Required: CH-4, CI-4 or
• Preferred oil: SAE 15W-40 (above 0°F)
• Alternate oil: SAE 10W-30 or 5W-30 (all
Toro Premium Engine Oil is available from your
distributor in either 15W-40 or 10W-30 viscosity. See
the parts catalog for part numbers.
17
higher.
temperatures)