Installing The Discharge Chute; Filling The Engine With Oil - Toro 38472 Operator's Manual

2
Installing the Recoil-Starter
Handle
No Parts Required
Procedure
Install the recoil-starter handle in the rope guide as shown in
Figure 4.
1. Rope guide
3

Installing the Discharge Chute

Parts needed for this procedure:
1 Discharge chute
2 Screws
2 Washers
2 Locknuts
1 Knob
Procedure
Install the discharge chute as shown in
Figure 4
Figure 5.
1. Knob
Note: Install the bolts from the inside of discharge chute
assembly so that the washers and locknuts are on the outside
of the chute.
Important: Do not overtighten the locknuts.
4

Filling the Engine with Oil

Parts needed for this procedure:
1
Bottle of engine oil
Procedure
Your machine does not come with oil in the engine, but it
does come with a bottle of oil.
Important: Before starting the engine, fill the engine
with oil.
Max fill: 0.35 L (12 oz), type: automotive detergent oil with
an API service classification of SJ, SL, or higher.
Use Figure 6 to select the best oil viscosity for the outdoor
temperature range expected:
5
Figure 5
2. Bolt (2), washer (2), and
locknut (2)