Servicing The Spark Plug - Toro 38472 Operator's Manual

Hide thumbs Also See for 38472:

Operator's manual (16 pages)

Operator's manual (20 pages)

Operator's manual (12 pages)

Table Of Contents

Table of Contents

backward (handle down) halfway to the ground to drain

the used oil into the oil drain pan.

Important: Do not tip the machine all the way

back to the ground, or fuel may leak out of the

machine.

4. After draining the used oil, return the machine to the

operating position.

5. Install the oil-drain plug and tighten it securely.

6. Clean around the oil-fill cap

7. Unscrew the oil-fill cap and remove it.

8. Slowly pour oil into the oil-fill hole. Wait 3 minutes,

then check the oil level on the dipstick by wiping the

dipstick clean and then inserting, but not screwing in,

the oil-fill cap into the hole.

Note: To determine the proper oil level on the

dipstick, refer to

Figure

Figure 27

1. The oil level is at its

maximum.

2. The oil level is too

high—remove oil from

the crankcase.

Note: You may tip the machine forward (handle up)

a little to make adding oil easier. Remember to return

the machine to the operating position before checking

the oil level.

Important: Do not tip the machine all the way

forward onto its nose, or fuel may leak out of the

machine.

Max fill: 0.35 L (12 oz), type: automotive detergent oil

with an API service classification of SJ, SL, or higher.

Use

Figure 28

to select the best oil viscosity for the

outdoor temperature range expected:

(Figure

11).

27.

3. The oil level is too

low—add oil to the

crankcase.

Note: Fill the engine crankcase with oil until the

dipstick indicates that the engine oil level is correct as

shown in

Figure

remove the excess oil from the drain plug into an oil

drain pan.

9. Screw the oil-fill cap into the oil-fill hole, and hand

tighten it securely.

10. Wipe up any spilled oil.

11. Dispose of the used oil properly at a local recycling

center.