Product Overview - Toro 38472 Operator's Manual

Hide thumbs Also See for 38472:

Operator's manual (16 pages)

Operator's manual (20 pages)

Operator's manual (12 pages)

Table Of Contents

Table of Contents

Adjusting the Control Cable

1. Slide up the spring cover and unhook the spring from

the adjuster link

(Figure

1. Adjuster link

2. Z-fitting

Note: You can pull up the adjuster link and cable to

make unhooking the spring easier.

2. Move the Z-fitting to a higher or lower hole on the

adjuster link as needed to obtain the 2 to 3 mm (1/16

to 1/8 inch) gap between the control bar and the

handle

(Figure

9).

Note: Moving the Z-fitting higher decreases the gap

between the control bar and the handle; moving it

lower increases the gap.

3. Hook the spring to the adjuster link and slide the spring

cover over the adjuster link.

4. Check the adjustment; refer to

Cable (page

6).

Note: The belt may slip (squeal) in wet conditions;

to dry out the drive system, start the rotor and run it

without a load for 30 seconds.

9).

Figure 9

3. Spring cover

4. Unhook the spring here.

Checking the Control